OK, I think I found the problem, but don't know how to fix it, hopefully Jim can on Wednesday. RJM and Dirtbanker you are closest to the problem.
I set my sprinklers Zone 1 to go on at 6:30 for 40 min, I set zone 2 to go on at 7:00 for 25 minutes, however Zone 2 wowuldn't start until Zone 1 finished its 40 min run. Zone 2 then came on and went through its full 25 min cycle. The other 2 zones followed suit and all 4 zones finished their cycles with no problem. I watch each cycle and everything was working with no problem, However, when Zone 4 finished, Zone 1 started the cycle all over again. At that point, I turned the system off. BTW, only Program A is set to on, B and C are off.
|