Quote:
Originally Posted by villagetinker
The KUS unit is the one I am looking at, I had already decided against the lever type as I had no way of determining the clearances in the tank. I was actually hoping to use the fill hole for the KUS unit, but I found actual dimensions and that unit is too big to fit in the existing hole. What I need to determine is if the tank has a completely flat bottom, so I guess I am going to jack up the cart and look.
|
Looking at the parts diagram the only place would be behind the filler cap towards the back of the tank.
I did some digging and if you want to have the stock parts the Yamaha part number for the fuel pump assembly with the level sender is J0D-13907-00-00 your cart has part number J0B-13907-00-00 which does not have the sender unit. You will Also need gauge JC0-H351C-10-00 and unfortunately you also need to replace the main harness with PN J0D-H2590-01-00 all in all it will cost you about $350, it will obviously entail a lot of work, you would have to take most of the body off the cart to replace the wire harness... I think it’s easier to go the aftermarket route!
I get all my Yamaha cart parts from adeptpowersport.com and sometimes partzilla.com.
If you do this work, consider taking some pictures of your progress and share it on the forum, I’m sure all this info will be helpful for others down the road.