Here’s an annoying problem that I’ve been unable to resolve even after reading and doing all of the “fixes” found in researching this....
Upon booting my Dell laptop, my Otium Beats will not connect. The settings say that they are “paired”. The only way they will “connect” is for me to do a “restart” of the laptop (NOT a full power off reboot). And yes, the Beats are in “discovery mode” when I attempt to connect.
Once the laptop “restarts”, the Otium Beats connect right away automatically. During my use, I can shut off the Beats, turn them back on and they connect immediately..... Soooo. I have done the following:
—Removed and re-installed the Laptop’s BLUETOOH drivers
—In settings, turned BLUETOOTH off, waited a minute or so, turned BLUETOOTH back on
—Factory reset the Otium Beats several times
—Removed the Otium Beats from the list of BLUETOOTH paired devices and “re- discovered them. However, getting them paired again will only work after I do the “re-start” procedure.
—I have made sure that the Beats are in “discovery mode” every time I try to connect to the laptop.
—I turn BLUETOOTH off on my cell phone which is the only device nearby that is paired with the Beats
—When connecting the Beats with my cell phone, they connect immediately
The Beats will stay connected all day long with the laptop (laptop stays on) even if I were to turn them off and come back later and turn them back on..... then the connection is immediate. If I walk out of range and come back in range, the Beats connect immediately....
So, all is OK until I power down the laptop..... The following day, the cycle starts all over again...... I have to fully boot the laptop and then do a “re-start” ...... Once the re-start is completed, then the Beats connect immediately....
Any thoughts ??
