Quote:
Originally Posted by Stephen13
It's not the fuel or oil, but the ignition coil is interesting. I was even thinking about the ignition relay. I tested the ohms on it and my multimeter was all over the place. I didn't know about the flashing light. How do you get that to display?
|
1. Turn main switch to on position.
2. Push accelerator pedal down to start engine.
3. The red check engine light will come on for about 2 seconds and then will go out.
4. Release accelerator pedal to stop engine.
5. With the main switch still in the on position, check the engine light. If it is not flashing, then there are not any error codes.
6. If the light is flashing, there are error codes. The light will flash at least one long flash followed by at least one short flash.
7. Long flashes flash for 1 second with a one second pause before the next long flash. Short flashes flash for .5 followed by a .5 second pause.
8. After an error code, the light will pause for 3 seconds and the start over. If there are multiple codes, it will display them right after each other with a 3 second pause in between and then restart the sequence. An error code will always start with a long flash and end with a short flash.