Problem Solved!
So, I finally had the opportunity to spend some time with my seat. The seat back has 4 threaded rods (bolts) that mount it against the metal supports. Initially the rods were all the way through the support and tightened down, with about 2 inches of bolt sticking out of the back of the support. So, I purchased 4 nuts and washers (the bolt is a ¼ 20 size), and I screwed the nuts ¾ of the way down the rod, so that there was just enough sticking through the support so that I could use the original nuts to tighten them down. That moved the seat back forward by 2+ inches, which was just enough for me and the wife to reach the controls better without the extra back support.
Problem solved, and it only cost me about $4 in nuts and washers.
I appreciate you guys helping me think it through!
|