Quote:
Originally Posted by BrianL
I just replace the outside sensor for my Hunter System after 7 years. A wired sensor comes with a very long wire attached. You remove the old sensor and cut the wire on the existing sensor. Tie the wire for the new sensor to the old sensor's wire and then pull the wire through the low voltage box in your garage. You open the Hunter controller and look at where the sensor wires are placed making sure you have the correct color with the correct terminal as you remove the old wire and put in the new wire. You'll have a significant amount of extra wire from the new sensor, you can cut this and strip the ends for putting in the low voltage box.
|
Thanks. It looks easy enough as long as the conduit is free of other stuff.