Quote:
|
Our lanai screen door woke me up @ 1:25am banging open shut in the storms peak gusty winds.
|
I have seen this problem. For me it was caused by the force on the lanai screen on the latch side of the door causing the vertical aluminum structure to which the sprung catch is attached to flex. It only needs to flex about 1/2 inch. This means that even locking the screen door does not help, because there is nothing to catch on.
In this storm, I used some strong 2 or 3 mm cord (climbing quality) and a trucker's hitch with a column that supports our roof at the other end from the latch. (I started with a standard taut line hitch, but it was not sufficiently taught. The trucker's hitch is easily tightened by the 2:1 mechanical advantage.) Even with that, the door itself was visibly flexing. You can remove the door, before the wind starts, but insects, frogs, etc. will probably use the entrance while it is open. The twine used at lumber yards to tie objects down to cars and trucks works well. Just use two or three Lengths of it for extra strength.
IAN (2022) occured before our closing and the rod on the closing piston was bent as a result of it slamming open. The technique above worked in Nicole, shortly after closing.
This time was different though. Two of the large lanai screens pulled out from the base. Peak winds were likely mid 60's mph here. Calling the pool installer later for screen replacement. They have all of the specs.
Another solution would be adding a horizontal beam at the level of the latch so there are two screens instead of one full height screen. That would prevent the flexing where it matters.