Quote:
Originally Posted by tommy steam
I agree with everything you said. I think someone trying to work in one of those type of attics ,would make a huge mess of the insulation up there.
|
I was crawling around up there last week to add an electric run, it's a pia to walk beam to beam, U can't see where you're stepping.
But the fluff fills right back in where your foot was.
When U get to where you need to and do work it does get disrupted for sure.
Almost need to bring a small rake to get back nice.
I would guess that if U hire someone to install the foil they mess up a lot it and don't reset it.
Oh at 10am it's really hot up there later must be unbearable.
Someone suggested a sheet be laid down first or a board????
Oh and you need a mask!
I'm skipping the foil idea that I thought I would do later.
I'm working on a new type attic fan design that can push 1,000 cfm each.
one or two of those on a temperature driven on/off switch say at 75 degrees looks like an easier way to go.
It should cut the attic temp down 30-40 degrees.
The fan(s) can run off 110volt or solar.
.