2000 gas ez go wont start
Hello Frank
my 2000 gas ez go will not start with it's battery fully charge it will turn over fast it will give a putt putt. if I jump start will another battery same thing I can use my 200 amp jump start on my battery charger it starts right up even with no choke. i messure the voltage from the charger at the battery while in jump start mode the voltages read 17 volts. after It starts i can hold the gas pedal at a level rpm and change the amps setting on the charger from 200 amps to 40 amps to 2 amp the rpm lowers as I lower the amps the voltage from the charger also lowers about 2 volt for each stage. the coil has 12 volts on red wire the voltage on white wire change while turning the motor over the primary winding on the coil messures 3 ohms.
The motor had been starting good when it begin to be hard to start after it would start it run very slow for about a minute all at once it would pick up and run normal.
Thanks
|