CYV Gate

[69Ludwigs]

Need to have our gate removed and then replaced after building a pool. Can anyone refer us to a competent contractor? Thanks!

[Topspinmo]

My CYV gate is held on by screws at the hinges. Just unscrew, are you taking bout the gate and the section to the house or out to the villa wall?

[69Ludwigs]

The gate itself and the section to the villa wall including the plats. I could probably get it out (and probably break it) but for sure couldn't reinstall it properly. Think We need a professional.

[Topspinmo]

Ok, maybe some one will give recommendations? I can't I usually do all my maintenance, another thing the pvc fence if few years old maybe brittle and no garrentee it will not come apart without damage?

[asianthree]

Need to have our gate removed and then replaced after building a pool. Can anyone refer us to a competent contractor? Thanks!

What about the company that is building your pool.

[Goldwingnut]

Insist your pool builder do it, they will need to take it down so they should put it back up, it should be a turnkey project for them not you having to chase contractors to do all the tasks.
If you're putting in a pool the company putting it in should be taking care of everything otherwise you will be spending a lot of time chasing down issues to complete the job. Our first pool in Florida (not in TV) we had different contractors for the pool, solar, sod, fence... Turned into a lot of extra cost and headaches.
When we built our pool in 2017 (also in a CYV), a turnkey project and price was paramount to me. Had to read the fine print on all the proposals to figure out what was not included. Finally went with T&D who was initially my last choice because I thought they would be the most expensive. Everything was done by them or they had it subcontracted out (e.g. the sod work, propane tank) but always just one person to call, no chasing contractors or prices. The final price by T&D, once I had an apples-to-apples design between the three contractors, was $1600 less than the other two and both of them I would have to deal with other contractors to finish the job.
You'll have to wait with T&D to get a price and them to start work as they are busy, in my opinion it was worth the wait.

[600th Photo Sq]

Need to have our gate removed and then replaced after building a pool. Can anyone refer us to a competent contractor? Thanks!


I can help you:

The company that you need to contact is Ro- Mac ...Leesburg

Telephone 352-787-4545

They are most likely the people who installed the original gate, very reasonable and honest.

Some of the replies here are useless and off topic...which is typical.:rolleyes: