View Full Version : Need someone to drill a hole
coffeebean
06-02-2018, 09:57 AM
I would like to relocate the screw that holds up the metal wall art on our house by the front door. The construction of our home is concrete, block and stucco. We don't have the proper equipment to make a hole for the screw that holds up the metal art. Do you know of anyone who can do this and is willing just to make one hole in the exterior wall of the house?
JoMar
06-02-2018, 10:20 AM
I would ask your neighbors....if it's anything like ours every tool ever made exists somewhere within a couple blocks. If your neighborhood is on Nextdoor, you can post it their also.
crash
06-02-2018, 10:26 AM
I am sure you have a drill then all you need is a carbide bit available at any hardware stores in the area.
BoatRatKat
06-02-2018, 10:37 AM
They make hardware (nail and hanger) that is made especially to use on concrete. I hammered the nail in and hung the metal wall art outside our front door and it's been securely there for the past 2 yrs. Cheap and easy.
coffeebean
06-02-2018, 03:14 PM
We do have a drill but it is not strong enough to drill into concrete.
BoatRatKat..... All I have to do is hammer in a nail to make a hole? My goodness. That seems easy enough. Where did you purchase this nail and hanger make especially for concrete?
DangeloInspections
06-02-2018, 05:27 PM
Dear Coffeebean,
You can do this a few ways, but the best way is typically using a carbide concrete drill bit and a cordless hammer drill and the correct Tapcon screw. These screws are made for concrete and are painted blue. As others have said, most folks have a handy neighbor close by who would do this for you, sometimes for the cost of one cold beer.....
They do make hardened concrete nails...I have used them before. You do need to be a bit careful with using them, and always wear eye protection.
Frank D.
villagetinker
06-02-2018, 07:20 PM
CoffeeBean, if you have not found a solution or help, send me a PM, i have the equipment to do this and have done this several times at my house and others.
coffeebean
06-03-2018, 09:09 AM
CoffeeBean, if you have not found a solution or help, send me a PM, i have the equipment to do this and have done this several times at my house and others.
Tinker.....thank you so much for your offer to help.
coffeebean
06-04-2018, 08:09 AM
Tinker....
I sent you a PM. (figured out how to do that!)
vBulletin® v3.8.11, Copyright ©2000-2025, vBulletin Solutions Inc.