Log in

View Full Version : Does anyone know what this is?


Juliewaters
04-03-2021, 05:25 AM
Hello. We just moved into the villages and noticed this round plate on the floor. I attached a pic. Does anyone know what this is for?
Thanks
Julie

Ragman
04-03-2021, 05:30 AM
Electrical outlet; there should be a wall switch (probably with a red dot) that controls it.

jswirs
04-03-2021, 05:31 AM
Hello. We just moved into the villages and noticed this round plate on the floor. I attached a pic. Does anyone know what this is for?
Thanks
Julie
electrical outlet, or junction box? If that has a screw I would remove it to access whatever is inside.

Juliewaters
04-03-2021, 05:42 AM
Thanks so much

Tmarkwald
04-03-2021, 06:21 AM
I have the identical floor outlet as well.

Jima64
04-03-2021, 08:43 AM
Floor outlet so you don't have to run an extension cord to have a lamp,near a piece of furniture.

tophcfa
04-03-2021, 08:55 AM
Hope it’s on a GFI, a water spill on the floor would not be good.

TommyT
04-03-2021, 08:55 AM
As was already stated, "Floor Electrical Outlet" but there is more to the story. One side of the outlet is always "hot" while the other side is controlled by a switch. In our Lantana, we had a switch by the back sliders and one by the front door.

JoelJohnson
04-03-2021, 05:19 PM
As was already stated, "Floor Electrical Outlet" but there is more to the story. One side of the outlet is always "hot" while the other side is controlled by a switch. In our Lantana, we had a switch by the back sliders and one by the front door.

Not sure you said it right, the "hot" side should be controlled by the switch, otherwise a short would make the whole box hot.

Kenswing
04-03-2021, 05:24 PM
Not sure you said it right, the "hot" side should be controlled by the switch, otherwise a short would make the whole box hot.
Our house is currently under construction. Those floor outlets are indeed 1/2 switched. One side hot, one side switched. We actually had them place two floor outlets in our living room. We'll use the hot sides for our motorized recliners and the switched side for lamps.

TommyT
04-03-2021, 07:08 PM
Not sure you said it right, the "hot" side should be controlled by the switch, otherwise a short would make the whole box hot.

NOPE !!!! One can make the outlet hot only on one side by pulling the dual contacts from each side. This makes the outlet have two circuit feeds.

thevillages2013
04-04-2021, 05:20 AM
The advice you have received already is good but just be careful when you take that plate off . Don’t assume there will be a correctly wired outlet under there. Proceed with caution

davephan
04-04-2021, 05:25 AM
If the outlet doesn’t have a wall switch, or any other outlet, you can add a Luton Castra wireless outlet switch, and then you can easily add a wireless switch to the wall. You can also switch the lamps on and off with a remote control, or your cellphone.

I’m changing out about 20 switches in my home. Most of the switches are incandescent only dimmers. I’m changing them out with Lutron dimmers that are incandescent / fluorescent / LED dimmers, then changing out dozens of incandescent bulbs with LED bulbs. Those lights can switched from your cellphone or automated.

I also changed out four mechanical wall timers with Lutron switches that can be programmed with your cellphone to turn on and off outside lights at sunset and sunrise.

I also added motion detectors to the lights in closets, the laundry room, and bathrooms, and countdown timers to the bathroom fans. The motion detectors are built into the switches, or are separate wireless motion detectors that can be “paired” to the switches. Then the lights turn on and off automatically. The fans shut off automatically.

You can even program the lights to make it look like you are home from the outside of your home at night with the automation. There’s a lot of things you can do to improve your electrical system in an older home.

GOLFER54
04-04-2021, 05:28 AM
I think it is a CCTV

NoMo50
04-04-2021, 06:51 AM
If yours is a new home, your builder should have explained that to you during your walk-through. You may also find several switches in the house that have a red screw on the switch plate. The red screw indicates that switch controls an electrical outlet. Find the outlet in the same room with a red screw on its cover, and the switch will control half of that receptacle...generally the top one.

jimkerr
04-04-2021, 07:26 AM
Hello. We just moved into the villages and noticed this round plate on the floor. I attached a pic. Does anyone know what this is for?
Thanks
Julie

It’s your electrical outlet

Bridget Staunton
04-04-2021, 07:50 AM
Electric outlet in case you want to put a chair or couch nearby. You can have a lamp on a table

DAVES
04-04-2021, 09:34 AM
The advice you have received already is good but just be careful when you take that plate off . Don’t assume there will be a correctly wired outlet under there. Proceed with caution


A very simple way to check. There is a plug device, sorry I don't know the proper name.
You will find it any any of the box stores at a cost of about $6.00. There are three neon bulbs in it and a chart on it. Depending on which bulbs light it will tell you if it wired correctly, properly grounded etc. It is not at all unusual to find someone replaced the outlet and connected it wrong or decided too much trouble to connect the ground. Also common on extension cords where people cut off the plug and replace it.

Finchs
04-04-2021, 09:58 AM
:bigbow:If the outlet doesn’t have a wall switch, or any other outlet, you can add a Luton Castra wireless outlet switch, and then you can easily add a wireless switch to the wall. You can also switch the lamps on and off with a remote control, or your cellphone.

I’m changing out about 20 switches in my home. Most of the switches are incandescent only dimmers. I’m changing them out with Lutron dimmers that are incandescent / fluorescent / LED dimmers, then changing out dozens of incandescent bulbs with LED bulbs. Those lights can switched from your cellphone or automated.

I also changed out four mechanical wall timers with Lutron switches that can be programmed with your cellphone to turn on and off outside lights at sunset and sunrise.

I also added motion detectors to the lights in closets, the laundry room, and bathrooms, and countdown timers to the bathroom fans. The motion detectors are built into the switches, or are separate wireless motion detectors that can be “paired” to the switches. Then the lights turn on and off automatically. The fans shut off automatically.

You can even program the lights to make it look like you are home from the outside of your home at night with the automation. There’s a lot of things you can do to improve your electrical system in an older home.

Villages Kahuna
04-04-2021, 11:18 AM
Hello. We just moved into the villages and noticed this round plate on the floor. I attached a pic. Does anyone know what this is for?
Thanks
Julie it’s an electrical outlet for a lamp or appliance in the middle of a room.

Ajiveson
04-05-2021, 02:45 PM
Hello. We just moved into the villages and noticed this round plate on the floor. I attached a pic. Does anyone know what this is for?
Thanks
Julie

Hi Julie,
I believe there is an outlet under it. It allows you to plug in the middle of the room without dragging a cord across the floor.