![]() |
flickering lights in our kitchen
For the past few months when we put on lights in the kitchen they flicker for about 20 seconds and than they are fine. There are 4 lights going on and they are all doing this.
Any idea why this should be happening and what to do about it? Does not happen anywhere else in our house so scratching my head about this. |
Try changing the light bulbs, I am assuming these are LED type, and I have seen strange operation when they are starting to fail. I would change all four bulbs and see if the problem is eliminated. Next would be changing the dimmer, once again I have seen strange operation with these. Double check that all wires are tight on the dimmer. The last item may require an electrician to check the wiring connection in the first light in the string of lights as i have seen intermittent operation that clears up when the connection heats up.
Does this happen all the time, at all times of the day? Are there any other electronic controls on these lights (Alexa, Apple,Ring, etc.)? Are all the lights the same, all LED or all incandescent? |
Quote:
|
LED lights that are not designed to be dimmed, can flicker when on a dimmer switch. There should be words about that on the bulb itself.
If you have non dimmable lights, perhaps the dimmer switch got bumped down slightly from full brightness. The flickering can stop as the light heats up. That "heat up" effect is a bad thing, and a main reason why you never want to put a non dimmable LED light on a dimmer - it's fire risk. |
Bulbs are worn out. Replace them.
|
I had a similar problem, called SECO (local electric co) and they found out that a vole had eaten the insulation on one of the main lines coming in underground. They patched it and it's OK now.
|
Quote:
Also how is it possible all four bulbs need replacement at one time? |
Keep it simple if all four lights are wired off one switch start there. Lights will be wired as a parallel circuit not in series. Power control starts at switch. IF switch is a dimmer it may be heating up and starting to fail. When dimmer is activated a resistance is applied to circuit “ Turning the switch gives a greater resistance, and hence a lower current through the bulb. However, the power that doesn't come out of the bulb is disappated across this resistor (it will get hot) most flickering is caused by an old, faulty or incompatible wall switch or bulbs that are loose or of poor quality.“.
|
Quote:
|
Quote:
|
Quote:
|
Quote:
|
Quote:
|
Quote:
I never know there was since a rodent in Florida |
The house is haunted. Sell it and buy a 4 bedroom.!
:MOJE_whot::ho::welcome: |
All times are GMT -5. The time now is 10:53 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Search Engine Optimisation provided by
DragonByte SEO v2.0.32 (Pro) -
vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.