![]() |
DIY Mini split system
Has anyone successfully completed a DIY mini split for a lanai. I am specifically interested in any potential pitfalls with building department inspections and permits.
I am looking at the Mr. Cool system specifically designed for DIY installation. Please feel free to use private message if necessary. |
Quote:
|
Just curious, how do you DIY pull a vacuum on the system? Or is it not necessary?
|
If you would just charge ten dollars for every helpful comment you have made, you would have enough to pay someone do it for you.
|
Quote:
|
I put one in a log cabin in TN. Drilling the hole was the worst part. As far as the inspection, you will need to have an electrician run a line near where the condenser will be placed.
|
Quote:
I ended up buying a tubular torque wrench to get the nut fittings torqued properly. I also bought a 90mm SDS plus shank drill bit to get through the block to run the lines. It was a $22 Amazon special, worked just fine but took a while. Figure out a way to have whatever is left of your coiled up lineset lines laying flat since you can't trim them. Do trim the electrical wire from the condenser to the evaporator but they come with premade connectors. There needs to be a disconnect at the unit. There should be a liquid tight flexible connection from the disconnect to the condenser. Plan on buying a ductless line cover kit to neaten up the install. I bought an outdoor wall mounting kit to mount to the block. If you go that route, do read the reviews, many of them are flimsy. I bought a very stout one. |
Quote:
|
Watch this video..
Here is a video I watched where this guy installed a Mr. Cool split system that I found very informative.
https://www.youtube.com/watch?v=Fbts4cbuSdY Seems easy enough ... |
Some more specific questions:
1. Were you able to use the new PVC pad for the outside unit? 2. How did you specify the de-humidifier operation only? Someone told me there was a module inside the unit??? |
Mr cool too expensive. Real AC companies will pull a permit and that will make it appear forever on your property tax. The solution: go on Facebook market place and search mini split. Lots of reasonable priced guys doing it under the radar with new equipment and no permits. And are still doing nice work.
|
Quote:
https://www.youtube.com/results?sear...+split+Mr+cool And if you would be so kind, provide an update if you complete the project including any videos that were helpful. |
Even if you install it yourself it is best to have the HVAC guy hook up the pre-charged lines to get your warranty from Mr. Cool.
Rite Temp is very reasonable and will install the equipment you buy. |
Quote:
|
Quote:
|
This might create a problem when you want to sell the property. The home inspection looks to see if permits have been pulled for qualifying projects.
|
Why would anybody install their own mini split system or put in a terrible looking hotel type unit on the side of your house? If any of my neighbors would put in 1 of those hotel units where I can see it, they would be reported, sorry.
Not all mini split systems are taxed or are put on your tax records, you buy 1 from a dealer that classifies it as a dehumidifier, plus you get a federal tax refund. I bought the better looking mini split that gets installed in your ceiling instead of having that big ugly unit on your wall. Sure it was another $1000 but well worth it to not have to look at the ugly indoor unit every day. Also, if you do put in a mini split, get a smart thermostat for it and throw away the remote you have to use. I have a unit that is comparable to an ecobee for my mini split unit to have different programming scenarios for heat, cool and time of day |
Let me clarify, I will be getting permits, building and electrical, but I had 2 estimates for this work, both were in excess of $5000 to $6000. This unit I am looking at is less than $2000, and allowing $500 for permits and actual inspections, there is a considerable savings. I was looking for the potential gotcha of using the unit as a dehumidifier only. I was told there was a "module" for this type operation, I will be calling Mr. Cool for additional info.
|
Mr cool mini split.
I installed one myself this past winter. My Lani is right around 600 sq ft, so I did go with the 12000 btu, so I could use 120 volt electrical, if you go higher than 12000 BTU, you do have to go 240. Also the 12000 BTU comes with precharged 25 ft cooling lines, and electrical line. Just follow their instructions, and you will be fine. I did buy the brackett that bolts onto the house, it is a very well made brackett, and does have a small level built right onto the brackett, and I also bought their package of covers to cover up lines. The only thing I hired out was electrical, because they do tell you to have a shutoff box next to the unit. I believe all the Mr Cool units heat and cool. I was really impressed by the heating and cooling of the unit. The whole package cost me around $ 2200 dollars.
|
Quote:
|
I just got an email from Costco and they have a Mr. Cool 24K btu mini split on sale for $1999 which is $300 off their normal price. I thought I would pass this info on in case it's a better price.
|
Looking further into this they also have the 18K btu unit on sale for $1899 and the 12K btu unit for $1449.
|
@villageTinkerer. Can you provide any update on your project ? I will be following in your footsteps.
|
Never installed, I tripped over the class 3 enclosure rules. Basically, you CANNOT get the required De-Humidity functionality from any of the companies that carry the DIY (Mr. Cool etc.), they will NOY supply the letter that the local A/C companies have been able to get for the Mitsubishi systems. Ths letter is required for the building permit, etc. So my only option is to pay one of these companies $5000 to $6000 to install the system that I could buy for $2000 and install myself. As for the class 3 rules, for Sumter County these state the room will not be air conditioned, hence the only option is the De-humidifier option.
|
Quote:
|
My intended usage is to cool / and reduce humidity in my garage. Does a garage install still require the letter for a building permit ? I get the sense it is related to square footage requirements, but frankly, I'm just wading into this pool and have a lot to learn on the ARC do's and don'ts.
|
Quote:
|
Quote:
|
All times are GMT -5. The time now is 11:32 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Search Engine Optimisation provided by
DragonByte SEO v2.0.32 (Pro) -
vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.