2020 Yamaha Drive2 headlight change
My 2020 Yamaha Drive 2 EFI left headlight went out. The manual says taking out 7 screws to replace the bulb. However there is no way to reach the screws without removing something - there is no room to reach the screws. After some research, it seems that I just need to take out the 3 fasteners holding the light housing on to the front body. I cannot figure out how to remove the fasteners without breaking them. Anyone with any good ideas?
|
If you have the factory HID lights, then Im not sure where the 7 screw thing comes from, because there are not 7 screws holding that light in. They use a push nut, on the lower side of the bezel. Carefully pry those off and slide the bezel assemble down and it will be in your had. However, there are 2 parts to make that light light, 1 is a module and 1 is the light itself. 99 percent of the time its the module that has gone bad.
|
All times are GMT -5. The time now is 06:16 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Search Engine Optimisation provided by
DragonByte SEO v2.0.32 (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.