Garage door problems
 

We had a power outage and I had to disconnect the garage door from the power chain in order to manually open the door. I attempted to reconnect the door to the chainwhen power was restored but failed a few times as it wouldnt engage. Now the door is flashing red and green simultaneously. I tried the reset button and the door either flashes red and green simultaneously or alternately blinks red, then green then red etc. Is there a solution to this problem?

I don't know, but Ryan O'Cull, 352-207-5668, or Scott, 352-697-0321 will fix it.

I wouldn't mess with it myself, unless you really know what you are doing. It could be dangerous. Most garage doors have a rope with a red handle to pull to disengage the motor.

Lever engagement
 

Run your garage door track all the way up even if the door stays down. Then make sure your handle is in the down engage mode. Then run your track all the way closed. The lever to the T handle rope attachment SHOULD engage. If you have a second door to view, you can see what I mean.

Post or get model number info from metal label on opener unit. Find manual online.

Ryan O’cull

What make of door is it?
I had a Genie door opener and had my up and down adjustment go goofy with those same flashing lights.
I called their 800 # and they walked me through it.

The problem is the chain will not activate at all with remote or wall. Blinking red and green lights are shown on the motor. I tried to reset the moto but would not reset. Unplugged, plugged back in. Used a paper clip to attempt to reset. Cant do it.

Its a MVP 1/2 horsepower Original home opener 2008

Ryan O’cull He’s the best

Ryan O’Cull fixed mine replaced bad control board

Just a thought...
Did you check to make sure the sensors (across the bottom of the door opening) were clear and "looking" at each other?

hit the button - recycle the door

Yep classic answer find the manual & read it

Masters Touch (352)347-6411 or
216-0060

Google it someone has a video showing a fix.