Directions to Mvp program garage door openers and keypad
 

This is directly from Romac

When your garage door is being opened by a neighbor follow the following instructions:

1) Erase the memory on your motor
a. Use a paperclip to press the program button (pinhole) located on your wall station
b. Hold the paperclip in the pinhole until the overhead light goes off
c. Do this twice
d. Try your handheld remote, it should not work. If it does, repeat step 1
e. If you have a keypad continue to step 2, if not continue to step 3

2) Program your OUTSIDE keypad to your motor
a. Use a paperclip to press the program button (pinhole) located on your wall station – just a quick tap in and out
b. The overhead light will go on and stay on
c. Press the “on/reset” button on the keypad and the red lights will come on
d. Slowly press the 4 numbers you want to use
e. The keypad will double blink and the overhead light will go off letting you know it accepted the code
f. Wait for the keypad lights to go off
g. Press the “on” button and type your numbers in and it should work the door.

3) Program your remotes to your motor
a. Use a paperclip to press the program button (pinhole) located on your wall station – just a quick tap in and out
b. The overhead light will go on and stay on
c. Press the button on your remote you use to open the door
d. The overhead light will go off letting you know it accepted the code
e. Press the button on your remote again and it should work the door
f. If you have any additional remotes:
i. Try any additional remotes you may have, if they work there are no further action needed
ii. if they do not work, repeat step 3 to reprogram

Thanks I’ll save it for future issues