![]() |
Does anyone know where the Xfinity modem goes?
1 Attachment(s)
I bought a 6 year old house in Linden and will be closing in July. Does anyone know where the Xfinity modem will go? The house was empty so I don't know where it was. In my prior house in Arizona, it went to a cabinet inside the walk-in pantry.
Below is a pic of the cabinet where I think the cable lines enter the garage. |
You can connect the modem to any active cable outlet in the house.
|
If you're only using WiFi, there may be a coax and power outlet above ta kitchen cabinet. If so, that's usually a good central location.
Welcome to the Villages! |
Quote:
HOWEVER, it looks like there might be other black cables that come in and go straight up and out to a room somewhere. If that is the case then I'm surprised that there doesn't appear to be a connector between the outside cable and the inside cable (unless it is hidden). (it's also possible that unused interior cables were left unterminated in he box with the ends pushed into the conduit to make the box neater) Regardless, you'll have to ask the previous owner or track the line yourself. Two ways I can think of to track it, buy a tester (fastest) or plug the modem into a location that makes sense and see if it syncs to the input signal (cheapest). |
I have mine in my office where I have a desktop computer. The desktop computer is direct wired to the modem with an Ethernet cable and it provides the fastest Internet speed.
|
Quote:
|
In other Linden houses, the ORANGE coax line is from Spectrum.
XFinity used black coax. So the Spectrum line goes to the ground block; extends to the splitter via a white coax, and then to 4 room wall jacks. If you subscribe to XFinity, and try to find the room jack on that splitter for their modem, you will not succeed. The XFinity line is harder to identify. It might be the unterminated coax on the bottom left. Or it might come thru the bottom next to the orange line and connected to one of the lines wrapped into the circle at the top right. In either case, it is NOT grounded. That is a risk during lightning strikes. With coax, unused connections on a splitter need a terminating resistor. If you are only connecting to a modem (not to any cable TV boxes) then you do not need the splitter. Connect the modem room coax line directly to the ground block. Connect the incoming data coax line also to the ground block. Done. Identifying the correct coax from the room can be done in 2 ways. Use a signal injector and tracer. Or trial and error - connect one coax at a time, and see if the modem locks onto a signal after a few minutes. That fails if the right coax line is without a connector. One final thing... Many houses of that age have what look like ethernet jacks in the rooms. They are not. Those are wires for old style dial-up telephone service. That is what the junction block in the top left is for. Plugging in ethernet cables to these jacks will not work. There might be zero signal or a bad signal. To get them to work, need new terminations at both ends, and a network switch in the garage cabinet. |
OK, the ORANGE cable is from the outside provider this could be Xfinity or Spectrum, (my replacement cable from Xfinity is orange), it goes to the ground block, and the to the splitter. There are four cables going to different rooms in the house, you should be able to plug in the modem/route and connect to any of these cables. I have suitable tools to trace the cables if necessary. You may have other cables that are not terminated, I also have some termination adapters.
Also, try to place the modem/router in a central location and as high as possible to get the best coverage. Send me a PM if you would like to discuss over the phone. |
Just let xfinity guy hook it up when you initially get service.
|
Quote:
|
Quote:
|
Quote:
|
Xfinity still uses coax cable, to the house and wall outlets. Centric will be fiber all the way to the modem, then using the superior LAN lines to the room outlets. Spectrum, I do not know what they use. A fiber optic/LAN line is superior/preferred over a coaxial cable line. Or you have which ever services modem/wifi router you can wirelessly stream to all your devices. But again, using the LAN is superior. If you care.
|
When a network question comes up in TOTV, you’ll get many different answers with many of them inaccurate.
Your xfinity modem can be placed anywhere where you have an rg6 cable. That can be in the wiring box in the garage, or it can be in any room in the house that has an rg6 black copper cable. If you think you will be fine with 1 router in your house, then position it in a central open position. But if you want very good coverage for your wifi signal, then you are going to need multiple routers (I use 5 routers) and you have the flexibility of putting the xfinity modem in the wiring cabinet in the garage and the 1st router in the garage next to the modem. Then you can convert or use the cat 5/6 blue wires to hardwire your next router(s) in your house, or use the mesh network backhaul when using the newer wifi 6e or newer mesh routers. I converted all my blue cat 5/6!wires from phone to Ethernet cables and use them to hardware the internal network when I can, and use the mesh backhaul network when I can’t wire. I did all the design and installation myself. I also use 3 1G 5-8 port switches throughout the house. No isp or geek squad person knows how to setup an internal network in your house. Never use a WAP or extender, they are junk. Design a network using mesh technology and you will be fine |
Quote:
|
All times are GMT -5. The time now is 11:36 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Search Engine Optimisation provided by
DragonByte SEO v2.0.32 (Pro) -
vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.