[spartanron]

Someone to program garage door opener.

[laryb]

1) Erase the memory on your motor

a. Use a paperclip to press the program button (pinhole) located on your
wall station

b. Hold the paperclip in the pinhole until the overhead light goes off

c. Do this twice

d. Try your handheld remote, it should not work. If it does, repeat step 1

e. If you have a keypad continue to step 2, if not continue to step 3



2) Program your OUTSIDE keypad to your motor

a. Use a paperclip to press the program button (pinhole) located on your
wall station – just a quick tap in and out

b. The overhead light will go on and stay on

c. press the “on/reset” button on the keypad and the red lights will come on

d. slowly press the 4 numbers you want to use

e. the keypad will double blink and the overhead light will go off letting
you know it accepted the code

f. wait for the keypad lights to go off

g. press the “on” button and type your numbers in and it should work the
door.



3) Program your remotes to your motor

a. Use a paperclip to press the program button (pinhole) located on your
wall station – just a quick tap in and out

b. The overhead light will go on and stay on

c. Press the button on your remote you use to open the door

d. Wait 15-30 seconds; the overhead light will go off letting you know it
accepted the code

e. Press the button on your remote again and it should work the door

f. if you have any additional remotes:

i. try any additional remotes you may have, if they work there are no
further action needed

ii. if they do not work, repeat step 3 to reprogram



When you are opening your neighbor’s garage door follow the instructions
below:



1) Recode your remote

a. Press and hold the “+” and then the “-“simultaneously on your
remote until the red light blinks release the buttons and the red light
should remain lit on the remote

b. Press the button you wish to open your garage door (either the
plus, minus or zero button)

c. Now you are going to press any button on the remote for a total of
nine times.

i. This
can be in any order or combination you wish, this will be your remote code

ii. For
example press: plus, plus, minus, center, plus, center etc until you
reached nine times

d. If done correctly the remote will blink after the 9th press of the
remote and the red light will now go off letting you know it is no longer
in program mode and has accepted the code.



2) See step 3 above



PLEASE NOTE: We recommend that you program your remotes and/or keypad
either early in the morning or late at night to reduce the likelihood of
picking up unwanted codes.

If these steps do not work, please call the office and schedule a service
call with a technician.



Carley BurrowAdministrative AssistantO: 352.702.3070

[EdFNJ]

Originally Posted by laryb

1) Erase the memory on your motor

a. Use a paperclip to press the program button (pinhole) located on your
wall station


(extraneous stuff removed)

How can you possibly know what model he has that will work with those instructions, since he provided absolutely no information?

[wisbad1]

Originally Posted by spartanron

Someone to program garage door opener.

If you go to Romac website, frank has all info for you to download. Tells you everything about openers.

[Bilyclub]

The MVP All Star. The loudest, most unsecure opener out there. Romac must have made a fortune supplying them and servicing them.

[jim1941]

Go to youtube.com. Type in garage door opener and model of opener.

[Topspinmo]

Originally Posted by Bilyclub

The MVP All Star. The loudest, most unsecure opener out there. Romac must have made a fortune supplying them and servicing them.

When they install cheap you don’t get the best. Be thankful it works.