Talk of The Villages Florida - Rentals, Entertainment & More
Talk of The Villages Florida - Rentals, Entertainment & More
#31
|
||
|
||
Quote:
"North of CR 466, homes are irrigated with potable water. South of CR 466, homes are irrigated with non-potable water which is comprised of storm water runoff that is collected in water retention areas and groundwater from the lower Floridan aquifer when storm water supplies are not available." Regardless of where you live in TV, the outside spigot water is potable. |
|
#32
|
||
|
||
Quote:
|
#33
|
||
|
||
No worries. Your question is a common one here, so now you know
|
#34
|
||
|
||
EdFNJ,
Did you get your answer, and were yo able to fix your faucet without removing it?
__________________
Pennsylvania, for 60+ years, most recently, Allentown, now TV. |
#35
|
||
|
||
Well, to get this back ON TOPIC the issue was resolved. After removing the one screw on each side side of the bibb and breaking the putty seal with a screwdriver I took my right hand (I'm lefty but had to reach behind the shrubs) and twisted counterclockwise 3 turns and removed (and replaced) the hose bibb thereby saving a fully licensed, fully insured and highly trained(?) 30yr old kid to charge me probably $200 to do the same. That savings covered one of our tickets to see Hamilton in Orlando next month. PLEASE DO NOT ATTEMPT DO THIS YOURSELF UNLESS YOU HAVE COMPLETE CONFIDENCE in your plumbing abilities. I am now awaiting an appearance from the water police for not yet installing the vacuum breaker which I did purchase for $9 (does INTENT count?). Still deciding whether to do that or to let our kids be forced to do it when wife and I move on to the netherworld and they get the house.
|
#36
|
||
|
||
Thank you, yes but it was much easier to remove and replace the bibb then to have to start cutting off the VB. See message right before this.
|
#37
|
||
|
||
Quote:
|
#38
|
||
|
||
Anyone know how outside faucet is connected to plumbing?
Quote:
That's blasphemous! Ok, did the homeowners home burn down? I've installed an entire new electrical panel . I've also done gas plumbing, water plumbing and a lot of electrical work in my home up north and IF YOU KNOW HOW TO DO IT (breaker) PROPERLY do you think you should pay an electrician to do it? I would never do anything like that for a neighbor for many reasons but for myself? Of course IF I am knowledgeable. Sent from my iPhone using Tapatalk
__________________
. . "If one has no sense of humor, one is in trouble." Betty White (1922-2021) R.I.P. Last edited by EdFNJ; 01-04-2019 at 02:37 PM. |
#39
|
||
|
||
If you install a vacuum breaker, I think it will work fine by either removing or not tightening the set screw. You can always install it later. But, once you tighten the set screw, you will not be able to remove it because it is designed as a tamperproof device. You may also be able to find a non-tamperproof set screw that could be removed to replace the vacuum breaker.
|
#40
|
||
|
||
Quote:
|
#41
|
||
|
||
Quote:
|
#42
|
||
|
||
Faucets
[QUOTE=EdFNJ;1612921]I guess it would be different depending on type of home. This is a wood frame built construction 10 yrs old in Amelia.
I'm pretty good at plumbing especially with CPVC pipe and I need to replace the outside hose bib. I removed the 4 screws marked with arrows. I am guessing the bib is connected to a cpvc to RESPONSE Hope it helps. The Hose bib may be on the house water line, and it may be on the irrigation line. You can tell by turning off the house water, in the wall, in the garage. OK, the back flow preventer, on the hose bib, brass POS is a real nuisance, I have always removed them, but save it because sale may require that to code? Years ago, someone with an IQ of 70 decided that all homes needed a BACKflow prevent er, because, it COULD BE? The hose with an insecticide sprayer may back flow stuff into the house water??? Think on that folks. So, I am not advising you to leave it off, but it is there to prevent, so, how to get back flow? Well there would have to be no house water pressure and there would have to be an elevation change or a pump to get the contaminated water back into the house ?????????? On two houses, I have removed and saved them, then able to install at the hose sale, if code wants it. Good luck. |
#43
|
||
|
||
Hose bibs
[QUOTE=EdFNJ;1612921]I guess it would be different depending on type of home. This is a wood frame built construction 10 yrs old in Amelia.
I'm pretty good at plumbing especially with CPVC pipe and I need to replace the outside hose bib. I removed the 4 screws marked with arrows. I am guessing the bib is connected to a cpvc to threaded adapter but don't want to twist it off and break it inside the wall. The bib seems to be attached (with sealant?) to that white block of whatever behind it. If I turn the bib with my hand the block moves so I am afraid I might break whatever water line is behind it.. Anyone ever take one of these off? Is it threaded to the cpvc? Replacing it is no problem if I can remove it. Response And,,,,,,,, I forgot, the POS brass prev enter can have a set screw in it to prevent removal,,,,,,,,,, need a small Allen wrench for the set screw removal. Village maintenance may know of the PVC or other threaded connection, Be careful, it is in the wall and so,,,,,,,,,,,,,,,,,do not break it. |
#44
|
||
|
||
IMO I would try to get repair kit and reseal it. The VB screw that's been broken off can be drilled out. Mine was also on the bottom I just used two pair pliers and turned till I could drill it out and un screw it using lots of Penetrating oil. just make sure you hold the valve good before trying to twist anything off.
DIY Repair your Leaky Sillcock (Outside Water Faucet) for under 7.50 and in 15 Minutes - YouTube Ok, after I researched the type you had and finished my post you all ready fixed it. Good Job another thing IF you replaced the VB just don't break the screw head off, that way you can remove it easily if ever has to be replaced again. |
#45
|
||
|
||
Good job.
__________________
It is better to laugh than to cry. |
Closed Thread |
|
|