Talk of The Villages Florida

Talk of The Villages Florida (https://www.talkofthevillages.com/forums/)
-   The Villages, Florida, General Discussion (https://www.talkofthevillages.com/forums/villages-florida-general-discussion-73/)
-   -   Check tire pressure (https://www.talkofthevillages.com/forums/villages-florida-general-discussion-73/check-tire-pressure-353301/)

tophcfa 09-28-2024 09:19 PM

Quote:

Originally Posted by JMintzer (Post 2374567)
Methinks he means "valve caps"...

Valve caps don’t hold in air, they protect the valve stems from weather and debris.

askcarl 09-28-2024 10:14 PM

Don't forget to trim your nose hair....

dougawhite 09-28-2024 10:17 PM

Quote:

Originally Posted by Bill14564 (Post 2374552)
The atom N is smaller than the atom O. However, the compound N2 is larger than the compound O2. Since we have to deal with the compound rather than the atom….

I stand corrected.
https://www.getnitrogen.org/pdf/graham.pdf

Bill14564 09-29-2024 05:59 AM

Quote:

Originally Posted by tophcfa (Post 2374579)
No, valve stems can leak air very slowly if they are not tightened down properly. There is a rubber gasket in the stem that needs to be compressed to hold in air. Over time the stems can loosen and require being snugged down, typically only about 1/4/ to 1/2 turn. Sometimes the rubber gasket in very old valve stems can corrode and the valve stem needs to be replaced. A valve stem wrench can be purchased at any auto parts store, or in the automotive department of a box store, for less than $5. A package of replacement valve steams can be purchased on Amazon for under $10.

Correct me if I am wrong but the valve stem is a 1" to 2" piece of rubber and metal that is inserted into the rim from the inside of the tire. It's purpose is to allow the tire to be filled with air through the use of a valve within the stem. There is usually a valve stem cap that screws onto the outer end of the valve stem to keep dirt out of the valve. In newer vehicles the valve stem frequently contains the sensor for the tire pressure monitoring system (TPMS). In all cases that I am aware of, the valve stem is replaced from inside the rim meaning the tire must be at least partially removed from the rim itself. The hollow rubber/metal valve stems can be fairly inexpensive but I know those that contain the TPMS sensor cost more than $10 each.

Perhaps you are referring to the valve itself which is within the stem. Those can be removed and replaced. In all the years I have owned vehicles (cars, trucks, motorcycles, bicycles, lawn tractors, golf carts, wheelbarrows, boat trailers, etc) I have experienced a bad valve only one time. Maybe I've been luck and it happens more often than that. I have never needed a replacement valve (I had the entire stem replaced that one time) but it's good to know they are available.

tophcfa 09-29-2024 09:36 AM

1 Attachment(s)
Quote:

Originally Posted by Bill14564 (Post 2374611)
Correct me if I am wrong but the valve stem is a 1" to 2" piece of rubber and metal that is inserted into the rim from the inside of the tire. It's purpose is to allow the tire to be filled with air through the use of a valve within the stem. There is usually a valve stem cap that screws onto the outer end of the valve stem to keep dirt out of the valve. In newer vehicles the valve stem frequently contains the sensor for the tire pressure monitoring system (TPMS). In all cases that I am aware of, the valve stem is replaced from inside the rim meaning the tire must be at least partially removed from the rim itself. The hollow rubber/metal valve stems can be fairly inexpensive but I know those that contain the TPMS sensor cost more than $10 each.

Perhaps you are referring to the valve itself which is within the stem. Those can be removed and replaced. In all the years I have owned vehicles (cars, trucks, motorcycles, bicycles, lawn tractors, golf carts, wheelbarrows, boat trailers, etc) I have experienced a bad valve only one time. Maybe I've been luck and it happens more often than that. I have never needed a replacement valve (I had the entire stem replaced that one time) but it's good to know they are available.

Ok, my bad, poor semantics. I should have said valve stem CORE (pictured below with tool). Advice still stands, they can come loose and should periodically be checked. They tend to become loose when frequently inflating/deflating and when running tires at low pressure. I had problems with the stem cores loosening on my truck when oversanding on the beaches at Cape Cod several days in a row (the tires are deflated to 11 psi to drive on the beach and then filled back up to 36 psi when getting back on pavement). The cores frequently loosen on my ATV as well. The tires on an ATV run between 3.5 - 5 psi. I’ve never had a problem on cars, but I did need to replace one on a golf cart.

Bill14564 09-29-2024 12:50 PM

Quote:

Originally Posted by tophcfa (Post 2374726)
Ok, my bad, poor semantics. I should have said valve stem CORE (pictured below with tool). Advice still stands, they can come loose and should periodically be checked. They tend to become loose when frequently inflating/deflating and when running tires at low pressure. I had problems with the stem cores loosening on my truck when oversanding on the beaches at Cape Cod several days in a row (the tires are deflated to 11 psi to drive on the beach and then filled back up to 36 psi when getting back on pavement). The cores frequently loosen on my ATV as well. The tires on an ATV run between 3.5 - 5 psi. I’ve never had a problem on cars, but I did need to replace one on a golf cart.

Terminology, ok, no problem. Understand now but still have not experienced that particular problem. Cheap and easy to check so why not?

Topspinmo 09-29-2024 08:40 PM

Quote:

Originally Posted by JMintzer (Post 2374567)
Methinks he means "valve caps"...

Me thinks it the jam nut that hold the tire pressure sensor onto rim?

Topspinmo 09-29-2024 08:42 PM

Use nitro not, the bottom line check tire pressure periodically and you won’t have wear or pressure problems. IMO periodically once month. But I’m willing to bet majority don’t do it and majority riding around with improperly tire pressure.

Kurtho 09-30-2024 06:06 AM

FYI. Costco has this little gizmo for those that don’t own an air compressor. Very convenient, as once you screw it onto the tire stem, it tells you the tire pressure, and you simply put in the desired air pressure and it automatically stops once you get there. Pretty small, and can be kept in a car or golf cart. $50 online or $40 in the store.

https://www.costco.com/fanttik-s100-...000230430.html

Bay Kid 09-30-2024 06:15 AM

Get a Yantu small air compressor from Amazon. They work great. I keep one in each car.

Altavia 09-30-2024 06:17 AM

Quote:

Originally Posted by Kurtho (Post 2374903)
FYI. Costco has this little gizmo for those that don’t own an air compressor. Very convenient, as once you screw it onto the tire stem, it tells you the tire pressure, and you simply put in the desired air pressure and it automatically stops once you get there. Pretty small, and can be kept in a car or golf cart. $50 online or $40 in the store.

https://www.costco.com/fanttik-s100-...000230430.html

Also handy for bike tires and multiple versions available on Amazon.

https://a.co/d/88qqCI5

dhdallas 09-30-2024 12:26 PM

Quote:

Originally Posted by string (Post 2373976)
After every hurricane check your tire pressure on cars and golf carts.
Hurricanes change the barometric pressure in the area.

Seriously? BTW, check your spelling in the title.

JMintzer 09-30-2024 06:54 PM

Quote:

Originally Posted by dhdallas (Post 2375046)
Seriously? BTW, check your spelling in the title.

That's your pull from this thread? So helpful...


All times are GMT -5. The time now is 07:15 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.
Search Engine Optimisation provided by DragonByte SEO v2.0.32 (Pro) - vBulletin Mods & Addons Copyright © 2025 DragonByte Technologies Ltd.