Yup....Did it to my friend

that' funny:wave:

irrigation system settings
 

I had the same issue. my water bill increased $75 and I have a small lot

I am now setting 2 x a week for 20 min in the front where I have a large shade tree. ( I keep an eye on it and so far so good)
my back is west sun and no trees. I do 40 min there 2 x a week
my sides i do 15 min 2 x a week. i turn it off if we have lots of rain. but water if only sprinkles between waterings. I agree better to use the water than resod the lawn

The general rule of thumb is 1 inch of water on each zone 2 times a week. The easiest way to check for 1 inch of water is to take a tuna fish can (opened and empty) and place in each zone. The can is 1 inch high.

Love your tuna can concept. Just in case..........."Open side up."


:1rotfl::1rotfl::1rotfl:

What you are doing will work, but you can accomplish the same thing by just setting a second start time on the same program (or "channel" as you call them). As long as you are running the same stations the same amount of time, using a second program is not necessary. Additional programs are only needed if you want to water some stations more often than others (e.g. shrubs twice a week and lawn 3 times a week), or if you want to deep water twice a week and syringe (running a station just a couple of minutes to cool the plant material down - not water it) twice a week on different days.

This whole issue of how much to water in Central Florida can be a bit confusing. I saw one watering regiment from the University of Florida (Lawn Care and Irrigation- Living Green - Institute of Food and Agricultural Sciences - Extension- University of Florida) that recommended a different watering time for each month of the year. Another University of Florida publication (ENH9/LH025: Watering Your Florida Lawn) recommends watering to a depth of 8" and watering less often as the temperatures moderate (I like this suggestion). It is very important that both St Augustine and Zoysia grasses get watered less often in the fall to prevent fungal disease problems.

Lot location is also important. Corner lots require more, ifyou are along a major road, even more since moving traffic causes wind which dries out the grass. I used to water based on cost, now I water based on how I want the yard to look (it took almost a year of different ladscapers and irrigation guys telling me I wasn't watering enough....can you say stubborn?). The plants and palm trees have been in over a year and we water them for 10 minutes in the cycle. You need to know how the plants you have handle water....you can over water plants. June, July, August and September get watered 3 times a week. Net 45 minutes for the grass, net 10 minutes for the plants.

I have 8 tuna cans in the garage that I use to test if I have any areas that do not get coverage :thumbup:

FL is different than places I have lived before. The sun is so hot that the plant dries in a matter of days. I think this is why BoSoxFan see better results.

I am not even close to an expert. My main goal is to balance the color of the grass and how much I have to pay 'the man' for the stinky water (south of 466). Last summer I barely had to water with the summer rains

Which terminal is the "blue" wire ? Not every tech follows a local color code.

I think it said "REM" on mine. Once I disconnected that, the seasonal percentage stopped being adjusted, but the sensor would still keep the system from running in the event of rain.

Yep, blue on REM. Thanks !

Sprinkler Settings
 

Found this...note "green" button controllers


PRO-C - UNINSTALLING A SOLAR SYNC SENSOR

If a Solar Sync sensor has been installed on the Pro-C controller then the seasonal adjust value used by the controller will be calculated from the weather data supplied by the Solar Sync sensor. If it is decided that the Solar Sync sensor will no longer be used with the Pro-C controller, it must be uninstalled.

If the Solar Sync sensor is not uninstalled, the controller will not allow the seasonal adjust value to be manually changed. For example, if the seasonal adjust value shown on the controller was 50% when the Solar Sync sensor was removed, it will remain 50% until the Solar Sync sensor is uninstalled.

To uninstall the Solar Sync sensor, simply disconnect the green and black wires from the controller terminal and then turn the dial to the SOLAR SYNC position. The display should show dashes, indicating that the controller no longer recognizes the Solar Sync sensor for calculation of seasonal adjustment. Now the seasonal adjust value can be changed manually by turning the knob to the “Seasonal Adjust” position and using the or button to adjust the value. After uninstalling the Solar Sync sensor, reinstall a jumper plate (or wire) on the sensor terminals or move the sensor switch on the controller up to the Bypass Position.

On the older model Pro-C controller (green buttons) remove the blue wire from the REM terminal to disable the seasonal adjustment feature of the Solar Sync. The Rain and Freeze sensor will still be active.