Originally Posted by rfc171 (Post 1936103)

With Massey Services, they do these maintenance for you! We had them for years!

Originally Posted by Annie66 (Post 1935959)

I respectfully disagree with your selection. The donut cutters available from Lowes or Home Depot are substandard in quality and durability. Neighbors have owned them and they struggled with cutting the grass roots (the cutting teeth are too short) and the strength of the welding. Failures occur when the welds break.

I purchased a heavy duty donut cutter from Florida Irrigation Service (FIS). They are located about 1 mile north of the intersection of CR42 and US441. Their donut cutter is a bit pricey, but worth the cost in reducing frustration.

Originally Posted by KAM+6 (Post 1936124)

When you cut the hole, cut a piece of weed block larger than the donut. Cut a hole in center for sprinkler head. Put it down under the donut. This will greatly reduce weed and grass growth around sprinkler.

Originally Posted by ironcitygetz (Post 1935658)

hello. we are in the village of bradford and looking for someone close who may have the tool needed to dig the hole for placing the donuts around the sprinkler heads. we are using the concrete ones, so i am not sure if there is a difference between the tool needed to do concrete versus plastic. thanks!

Originally Posted by bagboy (Post 1935677)

https://www.lowes.com/pd/Orbit-Sprin...Cutter/3420772

This is the tool you want.

Originally Posted by DeanFL (Post 1935688)

.
.
B4 you buy this one, read the reviews @ lowes.com --- cheap...FYI
.
.