View Full Version : Adjust the lie
The Villager II
01-14-2012, 03:34 AM
Who is best at adjusting the lie on clubs in the area? Thanks for any suggestions.
The Villager II
01-14-2012, 07:21 AM
bump. Anyone have name or location of a club repair that does lie angle adjustments?
getdul981
01-14-2012, 07:33 AM
Just tell the truth to begin with and you won't need any adjustment.
That's my story and I'm stickin' to it.
waynet
01-14-2012, 07:40 AM
I think the guys at Palmer could do it. Just be careful,can only adjust so much before you snap it.
graciegirl
01-14-2012, 09:08 AM
Sweeties says the guys at Palmer.
Tree Tops will do it too . . he did mine up 2 degrees . . . of course they were clubs I bought from him!
Mikeod
01-14-2012, 01:12 PM
A lot depends on whether they are cast or forged. Generally, forged clubs can be adjusted more and/or more often. Cast can break if you try to alter them too much. (From experience, unfortunately. :sad:) If they are Ping, I believe the factory will do the adjustment for relatively little, depending on the age of the club. Contact Ping Customer Service to be sure.
The Villager II
01-14-2012, 02:04 PM
A lot depends on whether they are cast or forged. Generally, forged clubs can be adjusted more and/or more often. Cast can break if you try to alter them too much. (From experience, unfortunately. :sad:) If they are Ping, I believe the factory will do the adjustment for relatively little, depending on the age of the club. Contact Ping Customer Service to be sure.
Thanks Mike. I went to Palmer and they said 1 degree only. If I am within one degree, I would just stay where I'm at. Went to Jim's Golf Shop by target and got a full education on clubs. They even gave me a test with my 6 iron and verified that I am making perfect center club contact with the ground. No Charge at all. I would recommend that store for sure. They were honest with me and could have taken my money, but checked me out and sent me on my way with a good feeling about my clubs and no charge.
vBulletin® v3.8.11, Copyright ©2000-2025, vBulletin Solutions Inc.