Talk of The Villages Florida - Rentals, Entertainment & More
Talk of The Villages Florida - Rentals, Entertainment & More
#1
|
||
|
||
![]()
You may recall my earlier thread:
"Driving home in the torrential rain last night the front and rear lights on my Par Car suddenly went off. Luckily I was only 50 yards from home turf. I checked the cart this morning and they flashed on briefly when I turned on the lightswitch, but no amount of on/off would get a second flicker. The flash would seem to rule out a blown fuse, so maybe it is just a rainwater incursion somewhere causing a short?" Discovered today that the turn signals don't work (nor their beeper) but the reversing beeper does, as does the horn. I tried the brakes and the brake lights flashed on briefly. I tried the lights again and they flashed on briefly. I think we can rule out fuses (or the brake lights and other lights wouldn't even flash) but is there a circuit breaker that could be being overloaded, then reset? Seems weird that some of the electrics are fine, but not all, unless some work on 12v and use a different circuit from those using 48v (if any actually do). As always, any suggestions gratefully received, before I call in the pros. Thank you |
|
#2
|
||
|
||
![]()
You are correct, there is typically a 12 system and a 48 volt system. In the newer electric golf carts they use a (in this case) 48 VDC to 12 VDC converter. I am guessing that this has failed, and the flash that you are seeing is the converter shutting down, either due to a short or that is cannot support the load due to a failure in the converter.
If you are familiar with the electrical system you might be able to isolate the converter, and connect a FUSED 12 volt battery to the golf cart 12 volt system where the converter normally connects. then you could start testing the various circuits, I would start with a 10amp fuse and ONE circuit at a time. I have small lead acid 12 VDC batteries that would be suitable, and fused test leads, so I may be able to help you. The DC/DC converters typically have built in circuitry to detect overloads and shut down the converter, and this may have been damaged by the water. This would explain a lot of what is going on. If this is the case, the converter would need to be replaced.
__________________
Pennsylvania, for 60+ years, most recently, Allentown, now TV. ![]() |
#3
|
||
|
||
![]()
Thank you for your kind offer to help, VT, but I think I'll just call in our usual guy as it needs a general service anyway and, from what you surmise, a sizeable replacement unit might be needed
Will post here what he finds out |
Closed Thread |
|
|