[erojohn]

I have a coleman propane heater i use for the Yamaha golf cart. It keeps falling out of the cup holder when i go over a bump. I have a foam cozy which helps keep it in but not a perfect solution. Does anyone have any ideas?

[Rango]

Bungie cords?

[spring_chicken]

I have that problem, also. It is so top heavy that it tips.

[wisbad1]

wanna sell it?

[Regor]

Trade it in for an Ez-Go. The heaters stay in the cup holders real good.

[Chatbrat]

velcro, or get an Atomic -its got a/c & heat

[baustgen]

Bungee cord works fine. Drill two holes underneath the dash, wrap the cord around the neck of the heater. Adjust length of the cords with nots until it is tight. You might have to spread the books slightly. Additional suggestion, go to the internet search on refill small propane bottles. Save money.

[Uberschaf]

3m spray adhesive.If you spray only one surface it is a temporary bond. Spray koozie inside and the outside on bottom and 2 inches up the side from bottom.Cleanup is easy with lacquer thinner.

[TVMayor]

Buy a snowmobile suit or a car.

[Rickg]

I wrapped the base with duct tape to make it fit snug