[Driller703]

Originally Posted by billethkid

The touch pad in the garage is not functioning consistently.....have to press up/down arrow more than once (to find spot that works).

Are MVP replacements available?

Can any brand touch pad replace the MVP unit?

Thanks.

Try new batteries.

[dougawhite]

Look through these on ebay. One should work as a replacement.

https://www.ebay.com/sch/i.html?_nkw...id=m5467.l1311

[retiredguy123]

Originally Posted by Driller703

Try new batteries.

I don't think the wall pad uses batteries.

[Rodneysblue]

Originally Posted by billethkid

The touch pad in the garage is not functioning consistently.....have to press up/down arrow more than once (to find spot that works).

Are MVP replacements available?

Can any brand touch pad replace the MVP unit?

Thanks.

Happened to me once. I accidentally nudged the lock button and would not allow the door to go up or down, double check your lock button.

[Astropoint]

Here’s a pic with an extra button next to door opener. Just bridge the two wires across the existing wires on the opener.

[PoolBrews]

Originally Posted by Driller703

Try new batteries.

There are no batteries in the wall unit.

[Bob45]

Originally Posted by billethkid

The touch pad in the garage is not functioning consistently.....have to press up/down arrow more than once (to find spot that works).

Are MVP replacements available?

Can any brand touch pad replace the MVP unit?

Thanks.

I have a touch pad, door safety lights and 3 remote openers for sale. PM me. Bob

[nn0wheremann]

Originally Posted by billethkid

The touch pad in the garage is not functioning consistently.....have to press up/down arrow more than once (to find spot that works).

Are MVP replacements available?

Can any brand touch pad replace the MVP unit?

Thanks.

You probably just need to remove it from the wall, take it apart, and clean the pad with a q-tip and some rubbing alcohol. Reassemble and remount on the wall. Should take about 20 minutes.

MVP was an odd-ball brand. They did not use the industry standard frequency for their transmitters so none of the commonly available replacements work with MVP systems. Mine lasted about 20 years, went through one start capacitor replacement ($25 at Granger in Ocala), and eventually the motor wore out.

I replaced it with a Chamberlain from Amazon. Installation was not much trouble. The new ones are much lighter. I had to buy a length of perforated steel bar from Ace hardware and cut two seven inch sections to extend the mounting bracket to mate with the old MVP bracket on the garage ceiling.

[drmatt1098]

Originally Posted by PoolBrews

I have one available to sell if you're interested.

Is the one you have available an indoor wall mount that allows for programming the code on a new remote?